From the brand
Product Description
OMPHOBBY M1 RC Helicopter
OMPHOBBY M1
M1 is a high-quality product created by the OMPHOBBY R & D team for helicopter enthusiasts. Its compact size makes it flexible for either indoor or outdoor violent flight.
Core Advantages
| | | |
---|---|---|---|
Adjustable Flight Controller Parameters | Dual Brushless Direct Drive | High-performance 3d Flight | High precision |

Dual Brushless Motors
- The dual ESC’s are improved using high-quality MOSFET’s with lower internal resistance, enhancing the flight characteristics even further.
- The built-in official receiver supports S-BUS and DSM / DSMX satellites.
- The flight controller has three built-in flight modes: stabilizing attitude, soft 3d and violet 3d.
- While in 3D mode you can quickly switch to attitude mode.
- The flight controller also has fully adjustable parameters including gyro sensitivity, rates, gain and servo mid-point position / collective.

About Flight Controller
Adjustable Flight Controller Parameters
Flight controller allows for adjustments of parameters to meet the needs of different flying styles. Improved ESCs with low resistance MOSFET pushes fight limit to a new level.
Adjustable Flight Controller Parameters
- Gyro Sensitivity: 9 levels for elevator and aileron
- Rate: 9 levels for elevator, aileron and orientation
- Gain: 9 levels for elevator, aileron and orientation
- Servo mid-point position / collective
Product Parameters
Main Motor | Sunnysky R23-2 |
Tail Motor | Sunnysky RO8-2 |
Main Rotor Diameter | 290mm(Approx 11.4in) |
Tail Rotor Diameter | 46.5mm(Approx.18.3in) |
Flying weight | Approx.118g |
Dimensions | 290mm*88mm*290mm (Approx.11.4in*6.46in*11.4in) |
Battery Type | 2S 350mAh 50C |
Flight Time(Max/3D) | Max flight time 9 mins, 4 mins for extreme 3D maneuvers |
Servo | All metal gear, ploy carbonate cased, high-performance servos |
Flight Controller | Receiver (integrated, also support S.BusDSMDSMX receivers)(Built-in FUTABA authorized SHFSS receiving protocol) |
M1 OMPHOBBY protocol version can directly bind the OMPHOBBY T6 remote controller, it comes with Futaba S.Bus interface and Spektrum DSMX interface.
M1 Futaba S-FHSS protocol version can directly bind the FUTABA remote controller, it comes with Spektrum DSMX interface. It cannot bind OMPHOBBY T6 remote controller.
BNF Package Include: (BNF version, no remote controller)
- Helicopter x1
- EEP Box x1
- Screwdriver x1
- Charger Cable x1
- Servo Horns x3
- Several Spare Screws
- Wrench x1
- Battery x1(Installed in helicopter)
NOTE:
- Remote Controller not included
- Battery Charger(2S/3S Balance Charger) not included
Important information
Legal Disclaimer
These products are intended for use only by operation experienced users or adults with assembly, setup, commissioning, flying at a legal and approved flying field/area. This product is not suitable for children or those who have no experience in remote control helicopters. Inexperienced users must purchase/operate under professional guidance.