This kind of micro servos can be used for helicopter, airplane, car and boat. It owns high quality and high cost performance. In the meanwhile, it is light weight and has a small size. I believe it is a good tool for you.
Stall torque: 1.8kg/cm
Operating speed: 0.1sec/60degree
Operating voltage: 4.8V
Temperature range: 0℃ ~ +55℃
Dead band width: 10us
Maximum rotation angle: 180 degrees
Gear medium: nylon
Working mode: Simulation
Yellow line (signal line)
Red line (power line)
4* SG90 9g Micro Servos
How to connect SG90 micro servo motor to Arduino Uno?
The connection with Arduino is extremely easy. The servo has three leads. The brown one is the Ground so connect to it Arduino Ground.
The red one is VCC which usually requires a voltage between four points eight to seven point two volts. So connect it to Arduino 5V.
The last lead, the orange one is the control signal which needs to be a PWM signal with a periodic time of twenty milliseconds aka 50 Hertz
and a duty cycle of one to two milliseconds so five to ten percent.
While an on time of one millisecond represents the -90° position of the motor shafts, one point five milliseconds represent 0° position and
two milliseconds the plus 90° position. That means you can rotate the shaft a total of 180°.