Please note:the FLYSKY FS-I6 is Left hand throttle(Mode 2), the throttle stick will not return to the center up and down.
The transmitter and receiver have been pre-bound before delivery.If you are using another transmitter or receiver, follow the steps below to bind to the B/VCC port on the receiver.
1, Connect the supplied bind cable to the B/VCC port on the receiver.
2, Insert power into any other port.
3, Hold the “BIND KEY” while powering on the transmitter to enter bind mode.
4, Remove the power and bind cable from the receiver. Then connect the power cable to the B/VCC port.
5, Check the servos’ operation. If anything does not work as expected, restart this procedure from the beginning.
Model Type: Glider/Heli/Airplane
RF Range: 2.40-2.48GHz
RF Power: Less Than 20dBm
2.4ghz System: AFHDS 2A and AFHDS
Code Type: GFSK
Low Voltage Warning: less than 4.2V
DSC Port: PS2;Output:PPM
Charger Port: No
ANT length: 26mm*2(dual antenna)
Transmitter Weight: 392g
Transmitter Size: 174x89x190mm
Package Size: 23.5×21.2×10.6cm
Package Weight: 676g
Power: 6V, 4*AA Battery(Not included)
Display mode: Transflective STN positive type, 128*64 dot matrix VA73*39mm,white backlight.
Model Memories: 20
Control Range: 500m
Frequency Range :2.4-2.48 GHz
Number of Band: 140
Transmitting Power: not more than 20dBm
2.4G modes: Automatic frequency second generation digital systems Encoding: GFSK
Input Power :4.0-6.5V DC
Dimensions: 40.4×21.1×7.35 mm
i-BUS Interface: No
Data Acquisition Interface: No
Usage: Suitable for RC Airplane/glider/helicopter
Compatible Transmitter: Flysky FS-i6,FS-I6X,FS-I6S
1 x FS-i6 transmitter
1 x FS-iA6 Receiver
1 x Manual